| Subject | Text |
| Philips 42PF9952 Plasma TV. Goes into standby after 1 sec. | Please help, I have a Philips Plasma TV, Model: 42PF9952 /39s.
When the TV is turned on, you get so |
| Sony KE-42TS1E goes into protection mode a couple of second. | I have a Sony Plasma KE-42TS1E which goes into protection mode a couple of seconds after switch on. |
|
|
| samsung 19" goes black | Hi my samsung 19" tv (probly 5 years old) has recently been going to all black except a narrow strip |
| My picture on my trinitron tv comes and goes | every 5 seconds or so. Any ideas? |
| Re: what other brands ... | [quote:3dde50b4cc="jts1957"]Some Zenith's were made by JVC.[/quote:3dde50b4cc]
Also can you pleas |
| Need Schematic for a NEC PlasmaSync 4210W | Need Schematic for a NEC PlasmaSync 4210W
or service manual
the problem is that. when I turn the p |
| TV Philips 32pw8506, entering SDM via pins Not working! | Hi there.
I played around with the settings in the service alignment menu(SAM), and now unfortuna |
| Philips Magnavox Projection 9P6034C103 | Iam looking for some service manuel. or one of those Files i can download, and it will help me Diagn |
| Sounds like your missing the blue component - is this the three connection type component video sign |
| 19" Curtis Mathis TV has black screen on the bottom 1/2 | A black box (screen) within the tv screen appears in the bottom 1/2 of the screen with the upper 1/2 |
| remote control URC24 | Hello,
These universal remote works fine on most devices !
First, you have to program the remote |
| philips 29' schematic diagram | Hi all,
After 10 seconds aproximadetly the TV goes to off, know some body how I can fix this probl |
| A CRT (picture tube) have 3 electron guns,each with their own filament, (heater) so you should see a |
| Sony KV-A2911S Television | TV starts up in coarse black and white, goes to colour after a few minutes and the flickers from B& |
| HI | I NEED A SERVICE MANUAL FOR THE RADIO IN MY CAR IT IS A FIAT PUNTO 60 S. the radio says volkswagono |
| repairing tek tds210 scope | hi all,
i recently got ripped off on ebay with a dodgy tds210 scope and dont know if ill get my mon |
| Right, lifted the anode of D812 of the +14V line that also goes to a 7808 regulator for the +8V supp |
|
|
| sony ccd-trv66 | Hi, I'm new to this forum so bear with me please. I have a sony ccd-trv66 camcorder that's been act |
| MS1181-2 CD Player Power control voltage low | Hello all
I have a koss MS1181-2 CD Player and when I use the power control to run a amp the amp |
| Often these errors are related to a bad solder joint on the main-pcb or crt-board.
You can check |
| I have found that the flyback goes bad on those models and, 2 caps of 250v-47uf go bad. |
| Alpine CDE-9827R schematics : : : please help me out! | hi, i got a Alpine CDE-9827R, with a blown output ic, and need schematics or some help... i have exc |
| How is the set stuck in standby? Are there any sounds coming from the back of the TV when you switch |
| Soldering help needed., It don't flow right | I’ve made my first DIY PCB, I’m trying to solder Leds into the holes and I’m a complete newbe, I got |
| Mag 810FD too bright | A hand-me-down from a friend. The monitor is too bright and adjusting brightness and contrast can't |
| PLASMA JVC GD-V4210 PCE no picture | hi i have a JVC GD-V4210 PCE it has power but it has no picture or the fans has no power the led goe |
| Re: sony trinitron, falt screen 32inch,where does this cable | [quote:7a6016dabd="CheM"]I got a TV for free, it is brand new, but the screen does not work. I opene |
| lost transistor for main board for Toshiba TV CX28519 | Hello, I was trying to repair a problem with thisToshiba TV CX 28519 chassis # 8915 and during my t |
| yes I have the service manual, I´ve downloaded from:
http://eserviceinfo.com/index.php?what= |
| Have you tried adjusting the picture from your pc's display card driver settings?
I think you can |